M-50 Engine

0

PrintPart specialists have developed the m-50 internal combustion engine using 3D printing for serial installation on civilian UAVs.

PrintPart specialists have developed the m-50 internal combustion engine using 3D printing for serial installation on civilian UAVs. At the design stage, 3D printing technologies are used, which allows us to enter mass production in accordance with the customer’s technical specification within 9 months. In the production process, the engine can be made of either metal or carbon-carbon composite materials.

Developed by PrintPart specialists, the M-50 engine achieves high performance , efficiency and durability, which creates wide opportunities for multirotor UAVs against the backdrop of the growing global and Russian UAV market.

Engine«M-50»
DesignDomestic carburetor four-stroke (4T) internal combustion engine with two lower camshafts and upper valves (OHV).
Working volumeок. 50,0 см3
Power4,0 л.с. (3,0 KW) @ 6.300 об/мин
Piston diameter41,8 мм
Stroke36,0 мм
Operating speed1.300 – 7.500 об/мин
Weight1.670 g. (including: motor frame with dampers, carburetor, ignition block, SM-6 spark plug, carburetor flap servo, rear Hall sensor, exhaust pipe, propeller mounting parts)
bent shaft3 ball bearings + 1 needle bearing
Rod2 needle bearings
Camshaft1 needle bearing
Cylinder lineraluminum with super-hard coating (domestic know-how)
Fuel1: 40 – 1: 50 (AI-95 gasoline + synthetic oilmotulcartgrandprix)
Ignitionrecommended: RcExel6, 0-12.0 V
CandleNGKСМ-6
hall sensorstandard at the back, can be installed on the toe of the motor in front, the sensor is suitable from rcexel Or similar units
Carburetorrecommended:WalbroHDA-6A orhda-246A. It is possible to install a different carburetor type Walbroot benzotehnika with a working volume of 35 cm3)
Assigned resource100 operating hours at 96% maximum gas (before service)
2-blade screw21 x 14 wooden Fiala @ 6.100 rpm 23 x 8-angle Mejzlik 21 x 11 wooden 3W
3-blade screwNo data
4-blade screwNo data